GHD Helios Repair
No fix, no fee · 12-month warranty · Insured, tracked returns
Faults this covers
- Won't turn on, with no sign of life
- Blowing cold, or not getting hot
- Cutting out after a few minutes
- A new noise, a pop or a burning smell
- A damaged, split or kinked cable
- Switches that don't respond or only work in one position
More about GHD Helios repairs
The GHD Helios (model number HE001) is a powerful dryer, and it fails in a handful of familiar ways. This repair is one fixed price, £49, whatever the fault: I find what has failed, fit the part it needs and test it before it goes back.
Won't turn on. A completely dead Helios is usually the mains cable, a switch or the thermal fuse. The fuse is there to cut the power if the dryer overheats, and once it has blown, the dryer stays dead until it's replaced. If it overheated, I also look for the reason, which is often a blocked filter.
Blowing cold or not heating. The fan runs but the air stays cool. That points to the heater or the circuit that powers it, including the thermal fuse.
Cutting out. A Helios that runs for a few minutes and then stops is usually protecting itself from heat. Clean the filter first, as below. If it still cuts out with a clean filter, the fault is inside, and that's this repair.
Noise, a pop or a burning smell. Stop using it. A new rattle or whine is usually the fan or the motor. A pop or a burning smell can mean a component has failed. Unplug it and don't use it again until it's been looked at.
Damaged cable. The cable flexes where it enters the handle, and the wires inside can break even when the outside looks fine. If it only works with the cable held at an angle, that's usually the cause. I replace the cable rather than taping it.
Switches. The switches take a press every time it's used, often with damp hands. When one wears, the dryer may only run on one setting, or not at all.
Check and clean the rear filter first
A blocked filter makes a dryer run hot, cut out and blow weakly, and cleaning it costs nothing. Unplug the Helios and let it cool fully. Take the filter off the back of the dryer, following GHD's instructions for your model. Brush the mesh clean with a dry, soft brush, and wipe the housing with a dry cloth. Let everything dry if you've used anything damp, then refit the filter before you switch it on. If the fault is still there, book the repair.
What's included
The part your Helios needs, labour, a PAT safety test, tracked return postage and a 12-month warranty. If I can't repair it, it's no fix, no fee: I refund what you paid, less the return postage and packaging charge.
If yours is a different GHD dryer, see GHD Air repair or the GHD Air 2.0, Speed and Flight assessment. For costs, see how much a GHD hair dryer repair costs.